After replacing the film, it suddenly stopped being recognized.
PAGE INFORMATION
CONTENT
This post has been automatically translated.
I’ve been using the SMT24 without any issues for several years, but suddenly, starting a few weeks ago, there are times when it doesn’t recognize the device or goes blank when I turn it on.
I suspect this started after I replaced the screen protector, and the adhesive side of the Velcro on the protector is peeling off little by little on its own. (The Velcro is still attached, but the adhesive layer is separating from it.)
If I press down firmly on that area and then turn it back on, it usually takes two or three reboots before it’s recognized. Is this really
because of the screen protector? I bought the
screen protector from the Gunpower Smart Store—could it have been defective? Or
could there be another cause?
I suspect this started after I replaced the screen protector, and the adhesive side of the Velcro on the protector is peeling off little by little on its own. (The Velcro is still attached, but the adhesive layer is separating from it.)
If I press down firmly on that area and then turn it back on, it usually takes two or three reboots before it’s recognized. Is this really
because of the screen protector? I bought the
screen protector from the Gunpower Smart Store—could it have been defective? Or
could there be another cause?
- PREVRe: Program Freeze, Sensor Not Working 25.05.27
- NEXTRe: 필름 교체후 갑자기 인식이 안됩니다. 25.05.12
COMMENTS
NO COMMENTS HAVE BEEN REGISTERED.